Submitted by bastianstrauss on Sun, 09/18/2011 - 19:07
Posted in
Hi guys,
I just found the new Firmeware on your Website 0.90 and I downloaded it.
So the problem ist, that the ArduinoBaord Uno can't write this programcode on the Board.
The 0.81 Firmware have 26398 bytes (from 32256byte)
0.90 firmware goes up to 29916 bytes. I think the bootloader on the board needs more space, so the programcode is to big for the arduino.
Or where ist the fault?
If you're using an Uno, and
If you're using an Uno, and it's complaining that the firmware is too big to upload, then you'll need to fix the bootloader for the Arduino Uno, see: http://arduino.cc/forum/index.php/topic,64105.msg466703.html#msg466703
Some of the Unos were sent out with bad firmware, well, a lot actually. I've heard lots of reports from people that can't go over 28k sketch size with the Uno.
!c