Submitted by raulcrane on Sun, 12/18/2011 - 17:44
Posted in
Hello!I love the project acquired everything necessary for installation but I am not clear how to connect the trigger to my EOS 7D has a round connector with 3 pins inside and notas fit if someone did and shared with all this info I think will very useful for everyone!and many thanks to all for the effort unconditional!many greetings
Raul, You'll need a proper
Raul,
You'll need a proper connector for your camera, the easiest way is to take an existing cable and cut it off of a cheap intervalometer, or buy a Canon N3 cable that goes to a 3/32 (2.5mm) plug from any number of vendors that sell intervalometers/motion control systems, and sacrifice it if you don't have a 2.5mm jack in your project.
!c
Hello friend!Thanks for
Hello friend!Thanks for your response, I buy the cable as you indicated, I bought in Hong Kongwith a value of approximately € 4According to the scheme minie that in the photo attached here:
the connections are like that?
according to the scheme P $ 1 -------------- GND P $ 2 --------------- Focus P $ 3 --------------- Shutr
Thaks all
regards