Submitted by Inco on Tue, 08/10/2010 - 23:41
Posted in
Hello
what do you think about to add a command that resets all variables in the om, clear all the keyframes and clear all the actions, I think that it will be usefull when you are programming the om whith the slim.
best regards,
Inco.
Inco, the stop (vs. pause)
Inco, the stop (vs. pause) command does about half of that... It resets all state, except it does not wipe out any actions or unused keyframes. Of course, not resetting your motor / camera parameters as well. Do you want it wiped clean, like a reboot?
Sounds like an easy enough command to add - I don't see any reason not to... Might work best to trigger a soft reset, rather than use up memory re-setting dozens of variables. I'll see what we can do there.
!c
I will add my vote to add a
I will add my vote to add a soft reset as well. I have been wondering if this was already in Slim. I have noticed that when I set up my shots, sometimes I forget to start from scratch and the motor step counts that I have set up in my key frames have already been bypassed. A soft reset would be a nice addition to add to the beginning of my scripts.
Thanks,
David
I like this too. I will add
I like this too. I will add it to the UI when its ready.